swboy 2006-4-12 00:21
请问一下老师们？
SW工程图中，写一段Note，里面有个尺寸，这个尺寸需要标注上下公差。
请问，如何在note里标注上下偏差？谢谢。
zhanghui 2006-4-13 07:07
请问一下老师们？
[quote][b]下面引用由[u]swboy[/u]在 [i]2006/04/12 00:21am[/i] 发表的内容：[/b]
SW工程图中，写一段Note，里面有个尺寸，这个尺寸需要标注上下公差。
请问，如何在note里标注上下偏差？谢谢。
[/quote]
In the text input box, move the cursor to where you want to insert the dimension, then click the dimension in the drawing view. Its value will be displayed in the text input box. If the dimension has tolerance specified, the tolerance will be displayed too.
swboy 2006-4-14 00:25
请问一下老师们？
thank u very much, mr. zhang.
I tried this way you mentioned, only basic dimension could be transfered into the text box, no tolerance and no symbol( such as diameter symbol) copied.
My edition of SW is 2005, maybe something wrong with my operating. I will try it again.
thanks again.