查看完整版本: 求教制作钢丝架的方法

求教制作钢丝架的方法

我正在做一个放酒瓶的架子，材料是直径4 to 8 mm的钢丝。把钢丝弯折、焊接后电镀制成。
本来以为很简单，但在“扫描”时，出现“路径”错误。路径草图中的波浪形列阵是“不连续”线段。
另外，三围草图制作路径有点麻烦。不知有没有专门做这种钢丝架子的工具？
哪位高手帮帮忙？

[quote]原帖由 [i]K.Cen.gz[/i] 于 2007-3-20 01:48 AM 发表
我正在做一个放酒瓶的架子，材料是直径4 to 8 mm的钢丝。把钢丝弯折、焊接后电镀制成。
本来以为很简单，但在“扫描”时，出现“路径”错误。路径草图中的波浪形列阵是“不连续”线段。
另外，三围草图制作路径 ... [/quote]

you may use "frame generator"  to make it as well.

What is "frame generator"?Another software?Where can i find it?

[quote]原帖由 [i]K.Cen.gz[/i] 于 2007-3-21 01:27 AM 发表
What is "frame generator"?Another software?Where can i find it? [/quote]

a kind of  function of inventor. I'm not sure if earlier editions have it or not.

Click assembly panel, in pull-down menu, you can see it. perhaps it takes some time to learn.

Sometimes very efficient for  frame making.

3D草图，到现在我都做不成，不听使唤。

The right way to do it is to use 3D sketch.  I don't know what is your problem for using 3D sketch.  What error message did you get?

If your wires are composed by planar curves, you can also use sketched curves.  Otherwise, you can create work points, and then use 3D sketch to connect them.

[[i] 本帖最后由 zhanghui 于 2007-3-23 07:08 PM 编辑 [/i]]

您这个玩意属于“不可制造”的设计。不是改工程图的问题...

如果有照片，我可以试一下。