xyz 2005-5-29 21:35
How to input a fraction length?
Pls, how to input a fraction length (for example, a line is 4 5/8" long) when I draw a line.
Should I convert 4 5/8" into 4.625" first, then input 4.625 on Command Line? Command Line can not accept the space between 4 and 5/8.
Thank you very much!
zhanghui 2005-5-30 07:11
How to input a fraction length?
[quote][b]下面引用由[u]xyz[/u]在 [i]2005/05/29 09:35pm[/i] 发表的内容：[/b]
Pls, how to input a fraction length (for example, a line is 4 5/8" long) when I draw a line.
Should I convert 4 5/8" into 4.625" first, then input 4.625 on Command Line? Command Li ...
[/quote]
You should type 4-5/8". If your length is longer than 1ft, you can enter like this: 5';4-5/8"
Good Luck!
xyz 2005-6-1 00:10
How to input a fraction length?
yes. thanks!
I had known about that, i can set up different units with "units", and enter different value styles.
变形金刚 2005-12-20 16:09
How to input a fraction length?
it';s my question too. thanks.